| The point, or the toe point is usually used for leg lengths. This refers to where the points are placed at the toe of the weld. The points are the right toe points, the Inner Toe Point (14) and the Outer Toe Point. Usually the inner point is used, but some measurements such as convexity use the outer point.
[In NAMeS: By right clicking on either of these points, you can force them to be treated as a single point, and clicking on that single point will give you two points to use again. The outer (right) point goes where the weld material meets the surface of the plate. The left goes where the penetration first starts into the plate.] |
|